The principle of the spindle less rotary veneer peeling and cutting machine The peeling machine is used to peel wood segments into veneers. The general method of peeling is to clamp the ends of the wood segments on the left and right chucks and drive them to rotate. The spinning installed on the knife bed The blade of the knife is parallel to the axis of the chuck shaft and feeds along its vertical direction. Then it comes to cut a veneer of equal thickness in the direction of the annual ring of the wood section. Then whether it is a constant speed rotary cutting or a constant linear speed Rotary cutting, in order to obtain a certain thickness of the veneer, it is necessary to make the feed rate of the cutter bed remain unchanged every time the chuck axis rotates, and the feed rate is equal to the nominal thickness of the veneer, then come If you change this feed rate, you can obtain veneers of different thicknesses.
